Several Issues Encountered using ReportSync #47
Description
I have the following feedback on ReportSync 1.1.2
Overall this process was VERY helpful, but there are some issues that required
some investigation. I have posted the major one – Shared Datasource not being
set as Defect#45
Below are the other issues I encountered
#1. When clicking on Load it would be nice to get feedback that it is doing
something
#2. It is not clear if you have to select the destination folder – especially
on subsequent syncs
For example sync was done for most all categories and reports
Doing sync again select 1 report in a category that was not migrated. Do you
check anything on the right? If I don’t the report gets put at the root.
So then check the category box, but then it sync’d ALL the reports. I only
wanted one report – see below on all reports being checked
#3. If you check the box on the category all reports beneath that category are
not selected, but if you save and open it open, then all will be selected
#4. It takes a bit for the sync to start, an hourglass would be nice
#5. The status bars stay completed after clicking OK that the ReportSync
completed
#6. (this is defect #45) After migrating the report will not run as the shared
data source for the report server is not valid:
The report server cannot process the report or shared dataset. The shared data
source 'AutoGen__5C6358F2_4BB6_4a1b_A16E_8D96795D8602_' for the report server
or SharePoint site is not valid. Browse to the server or site and select a
shared data source. (rsInvalidDataSourceReference)
Selecting Manage for the report, then Data Sources shows:
AutoGen_5C6358F2_4BB6_4a1b_A16E_8D96795D8602_
A Shared data source is selected
Select a share data source [Browse]! The shared data source reference is no
longer valid
I can be reached at TomG @ hp.com
Thanks
Original issue reported on code.google.com by jonathon...@gmail.com on 10 Jun 2014 at 10:01